Neunaber Technology Wet Reverb V1

General

• True Bypass
• Controls
• Mix knob: controls the reverb level. Full counter-clockwise is dry (no reverb). Full clockwise is about 50% dry/50% reverb signal. To achieve 100% reverb signal, see Effects Loop Switch, below.
• Depth knob: controls the decay time (length of reverb tail). The depth knob also changes the tone, from a little splashy (full counterclockwise) to slightly mellow (full clockwise).

• Effects Loop switch: It is located inside the pedal on the lower right edge of the circuit board. Use a pointed object such as a pen to change the effects loop mode. The position of the switch is shown on label attached to the circuit board. The effects loop switch switches between series (normal) or parallel effects loops. When the parallel mode is selected, only the reverb signal is present on the output. In this mode, the Mix Knob adjusts the reverb level.

• Connectors: Input, Output, DC In

Technical Data

• Input Impedance: 1 MΩ
• Input Level:  6 V max
• Output Impedance:  470 Ω
• Frequency Response dry signal: 20 Hz - 20 kHz, +/- 0.1 dB
• Total Harmonic Distortion: 
• bypassed: < 0.001% 20 Hz - 20 kHz
• enabled, dry signal: < 0.01% @ 1 kHz
• Signal-to-Noise Ratio:
• enabled, dry signal: 108 dB, unweighted, 22 Hz - 22 kHz bandwidth
• enabled, knobs at 50%: 102 dB, unweighted, 22 Hz - 22 kHz bandwidth
• Power: 9V DC Adapter (center negative) or 9V Battery
• Current Draw: 30 mA
• Dimensions: 2.8 x 4.5 x 1.85" / 71 x 115 x 47 mm
• Weight: 7 oz. / 200 g (without battery)