Vocoder en mode performance

Citation :
Bad_mister à écrit :

So, for example, the basic fundamental vocoder Voice is the "FUNKY vocoder" located at PRESET 8: 126(H14)

Say you want to use this in a PERFORMANCE
Place this Voice as PART 01 of your Performance.
Also the following conditions must exist:
In [UTILITY] mode, set the [F2] I/O = mic

In the PERFORMANCE
Press [EDIT]
Press [COMMON EDIT]
Press [F4] AUDIO IN
Press [SF1] OUTPUT
Set the AD PART Input parameter: Mono/Stereo = L mono (or the jack you used)
Set the AD PART: OUTPUT SELECT = INS L
This will route the output of the AD Part into the Large Insertion Effect of the "Funky vocoder" Voice in PART 1.
The default condition in Performance is that all PARTS (including the AD PART) can recall Dual Insertion Effects. The vocoder is a Dual Insertion Effect applied to a synth Voice. Therefore, you can additionally add effects to your AD PART... Here's how:

While in [COMMON EDIT] and [F4] AUDIO IN
Press [SF2] CONNECT
Here you can independently apply two Dual Insertion Effects for your mic input.
[STORE] your PERFORMANCE.