Argus du Alexander Pedals Equilibrium DLX
Attention, cette cote argus a plus de 6 mois.
Les prix indiqués dans les petites annonces des particuliers sur Audiofanzine ne sont pas nécessairement les véritables prix de vente ou d'achat.Les annonces avec options, ou constituant un pack, ne sont pas prises en compte.
Fiche technique
- Fabricant : Alexander Pedals
- Modèle : Equilibrium DLX
- Catégorie : Multi-effets et autres effets à modulation guitare
- Autres dénominations : equilibriumdlx
Controls:
Rate (Level) — Adjusts the rate of modulation from a slow pulse to a rapid flutter. Turning this knob cancels the Tap Tempo setting. Holding down the Bypass / Level footswitch lets you adjust the overall output level of the effect. The Level setting is stored in the memory of the pedal for future use.
Depth — Controls the amount of modulation from barely perceptible to seasick.
Shape — Selects one of four waveforms to control the modulation effect: Sine, Ramp Up, Ramp Down, or Square.
Mix — Blends between the dry and the modulated signals.
*Hint: For traditional style tremolo, set the Mix knob fully clockwise.
Tap Tempo / Division - tap twice to set the modulation rate. The LED above the Tap switch flashes to indicate the current rate and division. Hold to toggle between normal-speed (green) and double-speed (red) settings.
Remote Tap Tempo Jack - connect a normally-open momentary footswitch to this jack to set the modulation time remotely. Hold down the remote footswitch to change tap divisions.
Mode Toggle:
Tremolo — Traditional tremolo based on the bias circuits from the earliest tube amps. Use the Shape control to morph from a very soft and smooth tremolo to a much harder burp-burp modulation.
Harmonic — Based on the vibrato circuits from the early ‘60s piggyback amplifiers. Blend in the dry signal for a queasy, seasick effect.
Vibrato — True '50s style frequency vibrato, just like Buddy Holly. Try it with a fast speed and 100% wet mix for the widest vibrato effect. Mixing in some dry signal makes the vibrato sound more like a phaser or photocell vibe unit.
Bypass Switching:
The Equilibrium DLX features buffered bypass switching with a soft-touch footswitch.
Power Supply:
The Equilibrium DLX requires a 9V DC power supply with a 2.1mm pin, center negative. The Equilibrium DLX is not designed to be powered on supplies higher than 9V and does not use a battery. The Equilibrium DLX should work fine on a multi-pedal "daisy chain" connector, but if you encounter excessive noise or hum try a separate power supply. The Equilibrium DLX requires approx. 75mA.
Distribué par The Effect Factory
