Annonces DBS 72115
Alerte nouvelle annonceImages
Vidéos
Fiche technique
- Fabricant : Marshall
- Modèle : DBS 72115
- Série : DBS
- Catégorie : Combos Basse
- Fiche créée le : 21/12/2014
1. Hi-sensitivity Input
Input for the connection of bass guitars with
lower output levels.
2. Lo-sensitivity Input
Input for the connection of bass guitars with
higher output levels.
3. Gain Control with Peak LED
Controls the level of input gain.
For optimum signal level the peak LED should
light occasionally.
4. Pre-Amp Blend Control
This control fully anti-clockwise routes the signal
through purely solid state input pre-amp circuitry.
Turned fully clockwise the signal is routed through
an ECC83 pre-amp valve circuit. The various
positions in between offer numerous combinations
of the brighter more percussive solid-state tone with
that of warmer more compressed valve tone.
5. Deep Switch
Push switch to add extra bottom to the low end of
the primary EQ.
6. Low Primary EQ Control
Rotary control that gives + or - 15dB cut and
boost of the lower end of the primary EQ.
7. Bright Switch
Push switch to add brightness and attack to the
top end of the primary EQ.
8. High Primary EQ Control
Rotary control that gives + or - 15dB cut or boost
of the primary EQ upper frequencies.
9. Graphic Equaliser
7 Band graphic equaliser offering + or - 15dB cut
or boost (centre flat) of the frequencies that proved
to be the most effective for bass reproduction in our
exhaustive listening tests.
10. Graphic On/Off Switch and
Indicator
Push switch to access or by-pass the graphic with
LED indicating on/off status. (The graphic is also
footswitchable by any standard on/off footswitch).
For the footswitch to function the front panel
switch must be in the ‘Off’ position.
11. Compression Depth Control
Rotary control for selecting the depth of
compression.
Note:
This control works in
conjunction with input Gain control (3).
The input Gain control should be used to set the
threshold level and the Depth control to select the
amount of compression.
12. Compression Threshold Indicator
LED which indicates when the compression
threshold is reached3. Compression On/Off Push Switch
Push switch which activates the compression
circuit.
14. Volume Control
Rotary control to set the overall output level of
the amplifier.
15. D.I. Pre or Post EQ Selection
Switch
Selection switch to offer a studio or PA engineer
with the choice of direct signal either before or
after EQ and compression has been added.
16. Power Switch
On Off mains power switch with LED indicator
and featuring soft start circuitry to minimise switch
on and switch off noise
Distribué par Algam / La boîte noire du Musicien
»
Autres catégories dans Amplis Basse
Autres dénominations : dbs72115