Argus du SWR Baby Blue II
Attention, cette cote argus a plus de 6 mois.
Les prix indiqués dans les petites annonces des particuliers sur Audiofanzine ne sont pas nécessairement les véritables prix de vente ou d'achat.Les annonces avec options, ou constituant un pack, ne sont pas prises en compte.
Fiche technique
- Fabricant : SWR
- Modèle : Baby Blue II
- Catégorie : Combos Basse
- Autres dénominations : babyblueii, baby blue ii, baby blue 2, babyblue ii
BABY BABY BLUE – FRONT PANEL FEATURES
• High (“passive/active”) and low (“active”) sensitivity 1/4" inputs
• Gain control with LED peak preamp clipping indicator
• Aural Enhancer Control
• 3 band semi-parametric EQ
• EQ bypass switch • Effects Blend Control
• Effects Loop bypass switch • Master Volume Control with LED peak power amp clipping indicator
BABY BABY BLUE – REAR PANEL FEATURES
• Side-chain effects loop
• Balanced XLR Output with select switch for Line or Direct Mode
• XLR pad (level) control with ground/lift switch
• 1/4" Line Out Jack
• Tuner Out Jack
• Headphone Jack
• 1/4" Extension Speaker Output Jack
• Speaker Fuse: 4 amp fast-blo
• Line Fuse: 3AG, 3 amp slo-blo (120V)
• 3-Position Tweeter Mode Switch (on back of cabinet)
SPECIFICATIONS
ELECTRONICS Note: All measurements were taken with a line voltage of 120VAC.
Maximum power at 1kHz under clipping
120 Watts RMS @ 8 ohms
160 Watts RMS @ 4 ohms
Power Amp Distortion (1kHz)
0.02% THD, 100 Watts RMS @ 8 ohms
0.03% THD, 100 Watts RMS @ 4 ohms
Intermodulation Distortion
@ 8 ohms, 100 Watts RMS, 60/7kHz, 4:1, =0.05%
Frequency Response (power amp): –3db at 10 Hz and 22kHz
System Distortion (Gain and Master Volume full, enhancer and tone controls set flat, 1kHz): 0.5% THD
Sensitivity (for full output @ 8 ohms, 1kHz): Passive/Active Input Jack: 10 millivolts Active Input Jack: 50 millivolts
Input Impedance Passive/Active Input Jack: 800k ohms Active Input Jack: 60k ohms Effects Return Jack: 27k ohms
Output Impedance Effects Send Jack: 100 ohms Line Out Jack: 100 ohms Tuner Out Jack: 100 ohms Headphone Jack: 100 ohms
Signal to Noise Ratio (unweighted) –72db (7 millivolts typical)
Equivalent Input Noise 2.5 micro-volts
Chassis Material Aluminum
CABINET
Outer Dimensions 13 7/8" W x 19" H x 13 7/8" D
Internal Impedance 8 ohms
Cabinet Construction Interlocking dado joints, glued and nailed, covered in blue carpet
Cabinet Material 7 ply, 5/8", waterproof, void free, birch or maple plywood
Speakers (1) 10" PAS driver (proprietary to SWR) (1) LeSon TLX-1 Piezo Tweeter
Passive Crossover Components Capacitors: polyester Coils: 1.7 milli-henry iron choke, low DCR, custom made
Grill Stamped 16GA steel, chrome-plated
Total Weight 39 lbs.
Distribué par fenderfrance
