Où acheter The Beast of Both Worlds ?
Moins
Il n’y a pas de petite annonce pour ce produit.
Fiche technique
- Fabricant : Arkham Sound
- Modèle : The Beast of Both Worlds
- Catégorie : Têtes d'amplis Basse
- Autres dénominations : thebeast ofbothworlds, thebeastofbothworlds
Amplificateur pour basse, classe D et pré-amplification à lampe
| Class D power section delivers 1200W into 4 ohms, 600W into 8 ohms. |
| 12AX7 preamp tube powered with a dedicated 300V supply (not a starved plate design) |
| -6dB input pad |
| Gain, Treble, Bass controls - uses a James Tonestack to provide a wide adjustment range with minimal interaction. |
| Range control – sweeps the tone stack “midpoint” anywhere between 150Hz and 1KHz |
| Hi switch – adds a “bright cap” to the circuit to open up the high frequencies a bit. |
| Mid switch – provides a healthy bump around 250Hz |
| Lo switch – another healthy bump, at 80Hz |
| HPF switch - passive filter set at 100Hz. |
| Integrated Subsonic Filter - active, 24dB/Octave HPF set at 30Hz. Tames low-frequency cone excursion, allowing for more power and clarity in the audio band. Filtering and buffering handled with premium Burr-Brown Op Amps. |
| Mute Switch. |
| Amplifier and DI Out Master Volumes |
| LED Clipping Indicator |
| Preamp Out and Power Amp In jacks double as a series, line level Effects Loop. |
| Speakon/1/4″ combo speaker jacks. |
| Balanced DI output, featuring a hefty Cinemag transformer for full frequency response. Ground lift switch for good measure. |
| Ultra quiet fan. |
| Turret board construction for high voltage circuits, Mil-spec Teflon wire, etc. |
| Top quality components throughout. |
| Heavy gauge aluminum chassis. 13″ x 13″ x 3.5″ overall dimensions. Weighs ~ 9.2 lb. |
| Anodized aluminum faceplate, rear plate, and all stainless steel hardware. |
| Optional handle. |
»
News
Autres catégories dans Amplis Basse
Où acheter The Beast of Both Worlds ?
Moins
Il n’y a pas de petite annonce pour ce produit.


