Convertisseur MADA 2A

Description

Convertisseur de mastering de haute qualité fabrication US en petite série trés rare.
Utilisé dans les studios de mastering mais aussi pour les mixes par sommateur, console Neve, SSL Dangerous, Api, Chandler, Manley etc ...
Trés peu servi

44.1k, 48k, 88.2k, 96k, 176.4k and 192k
IN/ OUT : WC, AES EBU SPDIF RCA XLR
Visible sur visite à Boulogne -11 01 STUDIO / STUDIO A
Prix Neuf 4900€
Facture possible HT

Digital inputs
There are two digital inputs on the MADA-2. One is configured as an AES-3 or AES/EBU input, and
the other is an SPDIF input. The AES-3 input is a 110 ohm, transformer isolated, and balanced XLR
input. Pin #1 of this input is connected to chassis ground through a 0.1 mfd capacitor . The SPDIF
input is a 75 ohm single-ended RCA input.
Analog Outputs
The analog output of the MADA-2 are balanced and floating with an output impedance of less than 5
ohms. Either balanced or single-ended loads may be connected to the output of the MADA-2 without
problem. When a single-ended load (unbalanced) is used, be sure to take the signal between pin #2 (hot)
and pin #3 (cold) of the input XLR. Pin #1 can be connected to either of these pins if desired.
Connecting pin #1 to pin #2 will produce an output signal that is out of phase, so normally pin #1 is
connected to pin #3 for single-ended loads. Pin #1 can be left floating too.

MADA-2 Specifications:
ADC specifications:
Sample Rates available : 44.1k, 48k, 88.2k, 96k, 176.4k and 192k
Level Calibration : 0 dBu Input = -18 dBFs
(Other calibration levels available on request.)
Analog Input Impedance = greater than 10k ohm balanced
Maximum analog input level is a function level calibration (no analog clipping).
AES3 (XLR) digital output impedance = 110 ohm balanced floating
SPDIF (RCA) digital output impedance = 75 ohm balanced floating
WC output = +5V (TTL) unterminated. Requires 75 ohm load termination at load.