Attwood Audio Concert Stage

• Fabricant : Attwood Audio
• Modèle : Concert Stage
• Catégorie : Préamplis à transistors
• Fiche créée le : 10/12/2013

 This Vinyl Phono Stage Pre-Amplifier was Hand built for you at our Specialist Analogue Audio Manufacturing Facility.

It is intended for use with low Output Moving Cartridges with Outputs Ranging from 2uV- 1mV

The input for the Cartridge Factory Set to 470 Ohms of Resistance

This pre-amplifier is supplied with a linear Regulated 24 Volt DC 300 mA External Power Supply, with Locking DC Connector, Mains Input Voltage requirements 230 @ 50 Hz,

Ce Marked.

With regard to the Installation we strongly recommend that you allow the Concert Stage to Standby for 5 minutes prior to use.

There are optional ground connections for the Turntable arm.

Low Output Moving Specifications

• Input 470 Ohms 100pF
• Gain@ 1khz 58 db
• Input Sensitivity 2uV- 1mV
• Proving Output Level 150 mV - 775mV
• Signal to Noise Ratio Typically better than 70 db ( Input Terminated)
• Input Overload 20dB
• Distortion better than 0.03%
• RIAA Response Accuracy Typically +/- 0.5%