Annonces BR10 Power Supply Unit
Alerte nouvelle annonceFiche technique
- Fabricant : Audient
- Modèle : BR10 Power Supply Unit
- Catégorie : Stands & Racks
- Fiche créée le : 13/11/2024
BR10 Power Supply Unit & BR10 Rack Unit.
PSU FRONT PANEL
INDICATOR LEDS
These little lights show you which of the power supply’s circuits are functioning. In normal operation, they will all light up. If they’re all off, you’d best check the power switch and the plug fuse.
POWER SWITCH
Pretty self-explanatory. If not, then the operation of the compressor ratio control could be lost on you.
PSU REAR PANEL
POWER INLET
Standard IEC socket. Nothing new here.
FUSE
As you've probably guessed, the fuse goes in here. Be sure to select the right fuse for your local mains voltage. Use 20mm T-type slow-blow fuses; 1.6A for 230V and 3.15A for 115V.
VOLTAGE SELECTOR
This should come pre-configured for your local mains voltage, but be sure that it is correct before using the unit. If you're travelling with your Black Series Rack, be sure to check the mains voltage where you are, too.
POWER CABLE
1.5m cable with a Neutrik PowerCon on the end of it. Yes, it looks like a loudspeaker plug. It’s not. Trust us. And please don’t try putting it into a speaker. Thanks.
Now that you’re all powered up, we can take a look at the business end of the system...
BR10 RACK UNIT (10 Slots)
The rack unit can house up to 10 Black Series modules. It has a rear connector panel with inputs and outputs for each module. The rack also facilitates the distribution of Word Clock between modules and the linking of compressors for stereo or multi-channel operation. Let’s face it, the less cables we have to deal with, the better.
I/O
Each bay has two inputs (A&B) and one output (C) associated with it. The diagram at the bottom of the rack unit illustrates how these relate to each type of Black Series module.
CLOCK IN/OUT
The operation of this connector changes if you have a Black Time Machine Clock generator module installed:
With a Time Machine module installed, the BNC is an output and can be used to send the Word Clock signal from the Time Machine module out to additional digital devices, such as recorders.
Without a Time Machine module, the BNC acts as an input, making Word Clock from an external master clock available to all ADCs, or other digital modules, in the rack.
CLOCK TERMINATOR
This terminates the Word Clock signal to ensure that clock pulses don't bounce around on the cable. That would be bad. Use this if, and only if, the Black Series Rack is at the end of a daisy-chain of Word-Clocked devices. DO nOT use if you're using a Black Series Time Machine module.
PSU INPUT
This is the input from the PSU. No, it won't work if you attach a power-amplifier to it. OnLy attach the power cable of an Audient Black Series PSU to this connector.
B INPUTS
This handy D-Sub gives you access to the B inputs of modules 1-8, so you can cable it up nicely. This 25-pin female connector follows Tascam DA88 analogue standard wiring.
C OUTPUTS
Another handy D-Sub, this time to connect to the C outputs of modules 1-8. Great for hooking up to a recorder. This 25-pin female connector follows Tascam DA88 analogue standard wiring.
Distribué par Audio-Technica Europe
Autres catégories dans Autres matériels audio & vidéo
Autres dénominations : br10 powersupplyunit, br10powersupplyunit, br 10 power supply unit, br10power supply unit