Retro Mechanical Labs EFC Studio

• Fabricant : Retro Mechanical Labs
• Modèle : EFC Studio
• Catégorie : Autres processeurs d'effets
• Fiche créée le : 02/05/2018

Version rackable pour le studio de la distorsion/saturation à haut niveau de gain Electron Fuzz Custom

• Unconventional tone control: The “Hurt” and “Pain” knobs work as tone controls, but are directly tied to the gain staging. When you adjust one your adjusting the dynamics of the circuit. Not just sweeping out hi or low end. This makes for very interesting textures and a wide range of possible tones.
• Parallel clean circuit: Use this to mix the original signal under the distortion. Drive the inputs harder and the “Bleed” becomes a softer overdrive.
• Input attenuation: “Input” attenuates the signal going to the distortion circuit. Less signal means less circuit compression.
• Balanced ins/outs: XLR ins and outs for studio uses. XLR outputs are active while using the front Hi-Z ins and outs.
• Linkable Hi-Z inputs: Plug a guitar or synth right into the front. When the inputs are linked a mono signal becomes stereo. It is possible to run the outs in front to an amp or other gear.
• Universal power: Internal regulated power supply. 85 VAC to 264 VAC. Ideal for international power grids. No wall wart needed.
• New Biasing mode: For more conventional decay response.
• Dimensions: 19″ x 5.5″ x 5″ deep.
• Panel meters: Supports both 2.5″ and 3.5″ panel meters. Look can vary depending on type used. Vintage and NOS panel meters will not match. When possible we will use the same style or manufacturer unless otherwise requested. Extremely mismatched meters my add to a more “Frankenstein-ish” look.