Annonces T560
Alerte nouvelle annonceForums Vinylrecorder T560
Images
Avis
4.5/5(2 avis)
50 %
50 %
Donner un avis
syl1971Awsome
Publié le 23/02/23 à 20:58Wondeful machine ! if you are patient accurate hard worker and have a GOOD contact with Souri"s Bros
this machine is for you, cutting Vinyl in 33 45 78 T is not something quick and easy to do, but
with a lot of practices and passions u will get a good commercial cutting with it !
this machine is for you, cutting Vinyl in 33 45 78 T is not something quick and easy to do, but
with a lot of practices and passions u will get a good commercial cutting with it !
10
»
radiobombcoupe de vinyle boutique
Publié le 30/06/14 à 01:09
(contenu en anglais)The T560 is a vinyl cutting lathe, cutting realtime using a custom metal yoke/support/cutting mechanism. It uses a Technics 1200mk2 [or later] for vinyl platter and playback monitoring arm.
A rack of analog gear is used to
1] optimize the signal for vinyl [subs/extreme highs, balance, stereo/mono control, horizontal treble, vertical treble].
2] Volume control of cut/playback monitoring.
3] Amp dispatch levels , 3 band eq, groove spacing, cutter diamond temp control, motor control switch
4] monitoring R/L/ST/horiz treble/vert treble
5] Peak metering
6] cutter amp
the cut vinyl extrusion is removed by vacuum pump directly from the cut.
sounds are 3D and fat. extreme care in set-up needed both sonically, and physically !
Some wow & flutter [option extra motor available], some background noise, like tape, but low.
very long learning curve ! loads of parameters to balance and each cut is different.
Good build quality. Good design.
Quality product.
A rack of analog gear is used to
1] optimize the signal for vinyl [subs/extreme highs, balance, stereo/mono control, horizontal treble, vertical treble].
2] Volume control of cut/playback monitoring.
3] Amp dispatch levels , 3 band eq, groove spacing, cutter diamond temp control, motor control switch
4] monitoring R/L/ST/horiz treble/vert treble
5] Peak metering
6] cutter amp
the cut vinyl extrusion is removed by vacuum pump directly from the cut.
sounds are 3D and fat. extreme care in set-up needed both sonically, and physically !
Some wow & flutter [option extra motor available], some background noise, like tape, but low.
very long learning curve ! loads of parameters to balance and each cut is different.
Good build quality. Good design.
Quality product.
80
»
Fiche technique
- Fabricant : Vinylrecorder
- Modèle : T560
- Catégorie : Produits divers
- Fiche créée le : 23/04/2011
The T560 is a vinyl cutting lathe, cutting realtime using a custom yoke/support/cutting mechanism. It uses a Technics 1200mk2 [or later] for vinyl platter and playback monitoring.
»
Autres catégories dans Autres matériels audio & vidéo
Autres dénominations : t 560, t560