SolidGoldFX Surf Rider III

• Fabricant : SolidGoldFX
• Modèle : Surf Rider III
• Catégorie : Réverbs Guitare
• Fiche créée le : 18/02/2015

Features

• Tone : Turning this knob to the left will make the reverb darker while turning to the right will make the reverb brighter.
• Res : This 3 position switch controls the resonance of the reverb signal by way of negative feedback. With the switch in the center position, the resonance circuit is bypassed. An internal trimpot allows you to dial in the low setting (down position) while the high setting (up position) is fixed.
• Decay : This knob controls the decay time of the reverb signal thus creating a vast range of sounds from small rooms to more ambient tones in addition to classic surf reverb.
• Depth : This controls the intensity of the reverb signal. When using the expression pedal input, set the Depth knob to the maximum desired setting. We recommend using the M-Audio EXP or Mission Engineering EP-1R Expression pedals.
• Level : This controls the mix level or volume of the reverb signal. This control is active in both Hi and Lo level settings.
• Boost Footswitch : This switch allows you to boost or cut the reverb level. When the Boost LED is on, the Hi level mode is engaged. When the Boost LED is off, the Lo level is engaged and a portion of the reverb level is reduced. An internal trimpot allows you to adjust to level reduction of the Lo setting. Turning the trimpot clockwise will reduce the overall reverb level of the Lo setting.
• Bypass Switch : Allows you to engage or bypass the effect. The Surf Rider III is True Bypass.

Power & Dimensions

• Current Draw : Approx. 53mA
• 9V DC Input : This pedal uses a negative ground, 9V DC power supply. Battery operation is not possible.
• Power supply or batteries not included
• Dimensions : 4.67" x 3.68" x 1.18" (119mm x 94mm x 30mm)

Source : http://solidgoldfx.com/products/surf-rider-iii

Distribué par Fred's Guitar