Vue d’ensemble
Vue d’ensemble
Fiche technique
- Fabricant : DPA Microphones
- Modèle : ST2006A
- Série : d:dicate
- Catégorie : Kits microphones
- Poids du colis : 1.5 kg
- Autres dénominations : st 2006a, st2006 a, st 2006 a
| Directional pattern | Omnidirectional |
|---|---|
| Principle of operation | Pressure |
| Cartridge type | Pre-polarized condenser, Twin Diaphragm Capsule |
| Frequency range | 20 Hz - 20 kHz |
| Frequency range, ± 2 dB | 50 Hz - 20 kHz with typ. 3 dB soft boost at 14 kHz |
| Sensitivity, nominal, ± 2 dB at 1 kHz | 40 mV/Pa; -28 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted | Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4 | Typ. 28 dB (max. 30 dB) |
| S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL) | Typ. 78 dB(A) |
| Total Harmonic Distortion (THD) at 1 kHz | < 1 % up to 130 dB SPL peak |
| Dynamic range | Typ. 114 dB |
| Max. SPL, peak before clipping | 141 dB |
| Switchable attenuator | 0 dB / -20 dB |
| Output impedance | < 200 ohm |
| Minimum load impedance | 2 kohm |
| Cable drive capability | 100 m (328 ft) |
| Output balance principle | Impedance balancing with Active Drive |
| Common Mode Rejection Ratio (CMRR) | > 60 dB |
| Power supply (for full specifications) | 48 V Phantom power (± 4 V) |
| Current consumption | 2.8 mA |
| Connector | XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase |
| Color | Matte black |
| Weight | 160 g (5.6 oz) |
| Microphone diameter | 19 mm (0.75 in) |
| Length | 164 mm (6.5 in) |
| Output voltage, RMS | > 5 V |
| Polarity | +V at pin 2 for positive sound pressure |
| Temperature range | -40 °C to 45 °C (-40 °F to 113 °F) |
| Relative Humidity (RH) | Up to 90% |
| Sensitivity selection tolerance (at 1 kHz) | ± 1.5 dB |
Source : http://www.dpamicrophones.com/en/products.aspx?c=Item&category=123&item=24421
Distribué par Audio 2
»
