BANK SAVE - UNISSONS NOUS !

salut tout le monde :)

après .. 4 ans d'utilisation je n'ai jamais JAMAIS réussit à sauvegarder et reloadé une banque entière.

un seul patch en sysex dans nuendo OK. mais toute la banque impossible. je me retrouve avec un fichier sysex qui, si je le recharge dans l'oméga me fait des caractères chinois et des sons zarbis.

gregg (SE) m'avait répondu un jour le message suivant :

Citation de SE :

ran into this issue myself recently with dp5 and a midi express xt.

apparently MIDI protocol has changed (Tim Caswell could explain it better than I––hit him up on the user's group).  if you "event list" edit the data and correct the "massaging" of it so it (the sysex stream) begins with F0 and ends with F7 you can skirt the problem (see attachments); that is until you save it again, at which point the MSB or the LSB get mangled––something about the start/stop commands not being allowed "at the ball" explain the mess.

use one of these:

https://www.snoize.com/SysExLibrarian/

http://www.midiox.com/

fix you right up.

j'ai beau essayé de changer ce F7 et F0 avec MIDIOX c'est toujours un échec.

donc si jamais vous réussit à faire ça c'est cool d'expliquer la procédure complête :p

et si vous ne savez pas ben ce serait super cool d'envoyer un petit mail à SE pour demander comment on fait ;)
l'union fait la force et devant le nombre de demande ils vont j'espère faire l'effort d'expliquer.

voilà le mail que je viens de leur envoyer (mais c'est pas le premier sur la question :P)
vous pouvez vous en inspirer pour envoyer votre demande :

 

it's about that BANK SYSEX.

for some reason i never can save banks :S

i'm sure if i understand how to do is i could post some usefull video on youtube an people out there would love to understand the process. i red your advice about F0/F7 but it's not workin  for me :p

what i do :

first thing is i try to LOAD only a known factory bank

i use MIDI-OX

first i take a traditional BANK such as BANK A.

i open sysex view in midi ox

command window / load file / i select the sysex

the sysex appears in the window with F0(start) and F7(end) as you said in your mail.

then i go command window / send sysex

i get a popup that tellsme sysex is beeing sent.

then OMEGA is "frozen" i have to power Off/On" but the new bank is stored correctly in the OMEGA. every thing works.

NOW (!) i try to save then load again my own bank

i select bank D

in midi ox i go SYSEX / receive manual dump

in OMEGA utility 4time / i select SAVE DALL

i see incoming sysex in MIDI-OX

then i check that the message starts with F0 and ends with F7. it does.

so i set OMEGA to bank C and try to load this bank in omega as i did above.

but this time when i power ON the OMEGA again, i get chinise data from patch 5 to 84

i attached the file that i saved and try to load back.

could you explain me what i do wrong ?

 

+