Bookmarkez un article, une news ou un tuto et retrouvez-le dans votre section "Mes signets" du menu membre.
6 nouveaux annuaires
Luthiers, Réparateurs, Cours de musique, Studios d’enregistrement, de mastering et de répétition... Suggérez l’ajout d’une entreprise, inscrivez la vôtre ou déposez un avis.
Alertes disponibilité et baisse de prix
Ces nouvelles fonctionnalités vous permettent d'être informé·e dès qu'un produit est disponible ou que son prix a baissé.
Tentatives d'arnaque dans les petites annonces
Nous faisons face depuis quelques mois à une recrudescence de tentatives d'arnaques dans les petites annonces. Suivez nos recommandations >
Payez en 3 ou 4 fois vos achats d'occasion
Achetez plus facilement les produits dont vous rêvez grâce au paiement en 3 ou 4x dans les petites annonces.
Notez AF !
Dites-nous ce que vous pensez d'AF sur notre page Trustpilot ! Nous lisons et répondons à tous les avis.
Sujet de la discussionPosté le 23/02/2021 à 11:27:04(GROS) Problème VIRUS TI
Bonjour,
un ami m'a laissé son VIRUS car il a un gros problème avec... les potards ne fonctionnent pas/plus ainsi qu'une grosse partie des boutons...
J'ai refait les soudures des connecteurs nappes et carte mère mais ça ne change rien.
J'ai constaté qu'il y a comme des traces de chauffe à ce niveau là.
Il fonctionne apparement en plug in mais je ne peux le confirmer car je ne fait pas de MAO si ce n'est que pour enregistrer puisque je n'utilise que des machines hardware.
j'ai contacté ACCESS pour ce fameux "problème" et ils m'ont répondu très très vite.
Thank you for your email. This sounds like a wrong setting for the potentiometers in the units CONFIG menu. The knobs can be switched off there if the "knob mode" is set to "off". Either check this parameter in the CONFIG menu of the unit (hit the CONFIG menu button left of the display and then use the PARAMETER buttons right of the display to go through the menus).
Another option is to reset the unit to see if this helps: unplug your TI from the computer, unplug it from power and also take the power supply out of the power socket. Also remove any other cable going from/to the Virus TI. Next only plug back the power supply into the TI and the power supply back into the power socket. Then reset the unit by holding down the Arp section "EDIT" button for a few seconds while the unit is in standby mode. Whenever this is done and the TI has booted up correctly, try it again.
ET ben, je me suis trouvé tout bête parce que c'est reparti comme en 40