Sujet Problème avec K2500R : Switch 110V/220V

Citation : ============================

In the back of my K2000 manual, it talked about adjusting
a little doo-dad by the power connector. I don't know if the
K2600 has the same connector, although it sounds like it does.

The procedure is basically:
- remove the power cord
- open the cover of the fuse compartment
- pull the voltage selection card straight out
- orient the card so the selected voltage is read along the bottom
- orient the selector pin to point up when the desired voltage
is readable at the bottom
- insert the voltage selector card with the printed side
facing towards the AC power connector,
and the edge marked with the desired voltage first
- if changing from 110 or 120 to 220 or 240, or vise-versa,
change fuses and fusing arrangement
- replace compartment cover
- verify that the indicator pin shows the desired voltage

DON'T DO THIS if the connector seems to be different
from what's described here.

For Europe with AC mains 220-240V 50Hz, there are two fuses,
type GDB 5mm x 20mm, quick-acting (F), low-breaking capacity,
250V, 0.50A fuse.

To change fusing arrangement:
- turn off the unit, remove the power cord
- remove the cover of the fuse/voltage select compartment
- loosen the Phillips screw 2 turns
- remove fuse block by sliding up, then away from the Phillips screw,
and lifting up from the pedestal
- invert the fuse block and install the 0.50 A GDB fuses in both the
upper (Hot) and lower (Neutral) holders
- slide the fuse block back onto the Phillips screw and pedestal
- tighten Phillips screw
- replace cover

====================