Ptite info : Autre Pedalier pour JamMan
- 1 réponse
- 2 participants
- 979 vues
- 2 followers
ticasso
Pour ceux qui ont d'autres machines (midi notamment) à piloter avec un pédalier, j'ai fini par touver, apres de longues recherches, que le "micro" Pedalier optionnel mais semble t'il necessaire
du JamMan pouvait etre remplacé par un FCB1010. il suffit de parametrer les sorties Relais et de degoter un cable en Y (ou de sortir le fer à souder !)Citation : Just thought I'd share this with everyone: Just picked up my DigiTech
JamMan (Yeah, actually developed by Lexicon) and it was WAY too easy
to control both loop selection and record mode with my FCB1010.
1. Make sure you have Direct Select disabled and that switch are set
for current feed in Global Configuration.
2. Connect the two switch outputs via a 1/4 stereo to 2 X 1/4 mono
cable (Right mono in switch 1, left in switch 2, stereo in the JamMan).
3. Pick a pedal for UP (increase loop #).
4. Edit the patch, disable program change message, and select both
switch 1 and 2.
5. Pick a pedal for DOWN (decrease loop #).
6. Edit the patch, disable program change message, and select switch
2.
7. Pick a pedal for Auto Record Mode.
8. Edit the patch, disable program change message, and select switch
1.
That's all there is to it!
I use the FCB1010 Edit Utility for Windows which makes the process a
whole lot easier. Also, I copied the patches to all banks, so that no
matter which bank I select, I always have access to these function.
(i.e., I use #09 for DOWN and #10 for UP, so #09, #19, #29, #39,
etc... get the settings for DOWN)
dommage pour le RC20 !
Bises à l'oeuil
@+
hitman
- < Liste des sujets
- Charte