A.O.M. Factory Invisible Limiter G2

• Fabricant : A.O.M. Factory
• Modèle : Invisible Limiter G2
• Catégorie : Limiteurs & maximiseurs logiciels
• Fiche créée le : 25/05/2016

Expanded version of the software limiter for Mac OS X and Windows, launched in 2016

• Easy Mode". the limiter shows only essential controls for rapid learning and practical use.

• Bypass Toggles bypass.
• Unity Gain Monitoring When enabled, inverse gain is applied the end of processing path.
• Mid / Side Toggles MS Encode/Decode sub-blocks. When enabled, most of signal path works for M/S pair instead of L/R pair. Mid/Side processing is effective only in stereo channel configuration. Under other channel configurations, the state of this switch is just ignored.
• BIAS Make sound fat/warm a bit.
• Modes: 
• Modern This mode has been newly introduced in Invisible Limiter G2. Slightly tight sound. Suppress This mode is similar to Invisible Limiter’s Suppress mode.
• Clip This mode is similar to Invisible Limiter’s Clip mode.
• Through This mode is similar to Invisible Limiter’s THRU mode.
• Controls gain amount applied before limiting. Six-segment gain button enables stepwise control in 1dB, 0.1dB, 0.01dB.
• Ceiling: Sets threshold which the output signal should not exceed
• Controls mix ratio between input signal and processed signal
• SC HPF: Controls cutoff frequency of high-pass filter inserted into internal envelope detector chain ; When SC HPF is enabled, the limiter enters ‘Compressor-Style’ because it cannot guarantee nonexistence of peak exceeding in output signal.
• DC Cut: When LED-style lamp is lighting, the high-pass filter before limiting is activated.
• Attack Knob Controls transition curve of reduction amount in attack phase.
• Attack Shape LED Button When enabled (blue), the shape of transition curve in attack phase is changed from
• exponential to sigmoidal.
• Release Knob Controls transition curve of reduction amount in release phase.
• Release Shape LED Button When enabled (blue), the shape of transition curve in release phase is changed from exponential to sigmoidal.
• Shape Mode Select Changes behavior of internal reduction-shape control. This will be effective only in Modern mode.
• soft knee
• Controls channel link amount. 0% means fully unlinked. 100% means fully linked.
• Attack Time LED Button Activate or deactivate manual attack time behavior.
• Attack Time Knob Controls attack time. When manual attack is enabled, the limiter enters ‘Compressor-Style’
• because it cannot guarantee nonexistence of peak exceeding in output signal.
• Release Time LED Button Activate or deactivate manual release time behavior.
• Release Time Knob Controls release time.
• Release Mode Select Changes internal behavior related to manual release time setting. This will be effective only in Modern mode.
• Dither Type Select Selects dither type. See the table below for each type.
• Dither Bit Depth Select Selects dither bit depth.
• Auto Black Button When active, dither signal is automatically muted for very low level input signal.
• Reduction Meter
• Output level meter
• Meter controls: 
• Peak-RMS Shows RMS and Peak value.
• Peak-VU Shows VU and Peak value.
• K-12, K-14, K-20 Shows RMS and Peak value. Meter scale is optimized for K-12/K-14/K-20.

• K-12/VU, K-14/VU, K-20/VU Shows VU and Peak value. Meter scale is optimized for K-System 1 K-12/K- 14/K-20.

• Supports 44.1k - 192kHz Sample Rate
• 64-bit Floating-point Internal Precision
• Latency Compensation (needs DAW's support)
• Factory Preset
• A/B Comparison
• Undo/Redo
• Reset to Default
• VST2, VST3, AudioUnit, AAX-Native