TB303, comment arrêter la lecture d'un pattern lors d'une synchro ?

Citation : dsl si g di une connerie je m autovire lol

Citation : Mon gars, mon boitier de synchro me permet juste de convertir du midi clock en DIN Sync 24

Citation : Il y avait un mec en suède qui fabriquait une boite (Midi clock) qui permettait ce genre de truc tu pouvais décider de repartir sur la mesure ou demi-mesure que tu voulais et bien syncronisé.

Citation : NULOGIC SYNCHRONIZERS WITH CONTINUE OPTION
Here are some informations about those new midi-to-sync converters, with the continue option !




About the problem TR-606,TR-808,TB-303 non-continue capability.

If you buy the NULOGIC MTS-2 MIDI to Sync24 converter, you will be able to
Continue your SYNC-24 instrument.

The MTS-2 has two different modes, one is called pattern-mode.
Pattern mode gives you the re-start capability at any beat-start, (start of
beat 1,2,3,4..) with the MIDI continue message. This function will be found
on some other equipement supporting SYNC24 Out.

But, there is another mode too, called TRACK-mode. In this mode, you have
TRUE continue capability of your TB-303,TR-606 and TR-808. Now you can Stop
your sequencer anywhere in a song, and Continue exactly from there.
This works guaranteed if you use CUBASE as sequencer, other sequencer
programs has to be tested to be sure.

When using CUBASE and the MTS-2 in Track-mode, this is what happens:

Case 1:
Sequencer put in Play
Sync24 instrument starts playing from the beginning
Sequencer Stop
Sync24 instrument stops
Sequencer put in Play again = MIDI Continue
Sync24 instrument continues exactly from where it was stopped
...and so on...or down to case 2...

Case 2:
Sequencer put in Play
Sync24 instrument starts playing from the beginning
Sequencer Stop
Sync24 instrument stops.
Sequencer Stop again, song-position pointer gets to your left locator.
Sequencer Start = MIDI Start
Sync24 instrument starts playing from beginning.
...and so on...or up to case 1...

This works because the Sync24 RUN-pin is held high/active during the above
Case1-scenario. But, when as in the Case2-scenario one more sequencer-Stop
is pressed, the Sync24-pin is dropped / deactivated.

This works very fine if you use the NULOGIC MTS-2 MIDI to Sync24-converter,
and Cubase as sequencer. It probably works fine with MTS-2 and other
sequencer. Like Notator and such. By the way, the MTS-2 has two Sync24-DIN
out, so one doesn't have to make that split cable the first day.

To get more info you might look at this web: http://www.algonet.se/~nulogic

Citation : pourquoi pas rebirth sur ce coup là?

Citation : Ma carte son n'est pas reconnue sous rebirth