depuis 1 ans qu'elle est là, verdicte elle est fiable ou pas ?

This was covered indepth on the OLD forum. TOOO bad PreSonus deleted the entire thread. Didnt want anyone to know about the production problems.

First go along the ENTIRE back panel and check every screw and hold down nut and make sure they are all tight. Especially the screws around the db25 direct out jacks.

Next unplug every cable except the power cable (SL turn off) and get an old battery powerd am/fm radio. Turn the radio to 100 Mhz FM. Hopefully you dont have a local radio station right at 100 Mhz. Turn the volume up on the radio till you hear just a little static. Now place the radio about a foot from the back of the SL and turn the SL on.. If your power supply is ok you should NOT hear any buzz or noise on the radio. BUT if you have a defective Power Supply (like a lot of people have) then you WILL hear the SL board microprocessor thru the radio. It will putting out a radiation pattern that effects the entire board and surrounding equipment. This test is called the "crap radio test". My SL was radiating so bad it affected some wireless radios the band was using. I had to go out in my back yard (about 75 feet or so) before the crap radio became quiet again.. Hopefully your SL is not radiating, but if it is stop and get an RMA and get the power supply replaced.

1. check all the screws.
2. do the radio test.

Both fixed my board of several problems..