Mon premier modulaire

Citation : mais alors que produit le vca qui génère des cv?

Citation : VCO-Scale, VCO-High-End-Trimm

The module should be connected about 30 minutes to power before adjusting the scale. Connect CV1 input of the A-110 to a MIDI-CV-Interface or another voltage source beeing able to produce 1.00V voltage steps.

Tune (P1 at front panel), range switch (SW1 at front panel) and trimming potentiometer P8 (high end trim) into middle position.

Adjust VCO scale (spread) with P7 so that a voltage differences at the CV input of 1.00/2.00/3.00/4.00/5.00V correspond exactly to 1/2/3/4/5 octave jumps in the VCO output (no matter which of the VCO outputs is monitored). At higher frequencies the scale may deviate from the correct setting. This has to be corrected with the VCO High End trimming potentiometer P8. The octave jumps can be measured with a "good ear" or with frequency measuring equipment. Pay attention when using a normal frequency counter as it has a very high measuring error at low frequencies. In this case it is better to measure the periode rather than frequency. Another way is the use of a reciprocal frequency counter which measures the frequency much more accurate at lower frequencies. If your counter displays e.g. 32Hz when measuring a low VCO frequency you have a normal counter. If the display shows e.g. 32,178456 Hz you have a reciprocal counter

Citation : Les modules MFB ne sont pas plus chères, quelqu'un a deja eu l'occas de les ecouter ( en particulier les VCO )?

Citation : VCF Russe de Harvestman

Citation : le AGF de Livewire (mortel aussi!!ca change des A110!!!! par contre il va falloir de je capte toutes les modulations possible...)

Citation : je viens d'avoir le VCF Russe de Harvestman (première impression, mortel!!je crois que je vais passer tous mes sons a travers!!!)

Citation : Je me demande toujours quel est l'interet d'avoir des modules non controlable en tension dans un modulaire? (comme les Fixed Filter Bank...)